What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 25.06.2025 02:30
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
There are two important concepts here.
2024–10–14 [Omar Gharbi Omar Gharbi ]
Teens like me, what are your expectations when entering adulthood?
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
This device then solves the entire problem.
This is where this question deviates from being a 'generic' question, and becomes more specific.
2024–10–10[John johnson John Johnson ]
These devices are installed between the “hot” and “neutral” and protective ground.
This is where the MOV conducts again, and dissipated the energy.
Patriots decline to say whether Stefon Diggs has passed key physical in contract - NBC Sports
What is lightning?
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Now when you have a certain ac resistance, then a current flows in a loop.
what exactly is a ‘surge’ protector?
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
The other is “what does a “fuse” do?”
First Sentence:
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
What styling mistake needs to be stopped in K-pop?
It seems Mohan does not understand the difference between a comment and an Answer.
It also is a device that limits the change in current flow.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Upvotes:
But it can get overloaded, and no longer works.
This one hit behind the barn.
Angelina Jolie’s Daughter Shiloh Debuts New Name for Choreography Work - Just Jared
the problem then depends on "how fast does the fuse operate?".
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
At least they know the answer if they wanted it.
IPOs That Launched Like Rockets — and Those That Flew Straight Into a Wall - PYMNTS.com
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
but this device (an Inductor) … impedes the rapid changes in the current.
For the first time, an external factor turns a male mammal into a female - EL PAÍS English
There are three different concepts here that are getting confused.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
so, what happens?
Kate Middleton shares heartfelt message after unexpectedly pulling out of Royal Ascot - Page Six
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
A Mesozoic myth: Dinosaurs didn’t rule the Earth like we think - Big Think
Because the load is inductive, the current lags the voltage.(by a bit).
(Dc diagram shown, AC is similar).
The MOV will conduct when the voltage exceeds 50% of line voltage.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
He then asserts :
Do they have internet in hell? Most people on here seem like damned souls or demons.
The third is lightning and “how it gets conducted into a home.”
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
He then describes the function of a fuse.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
eight
An AC voltage/ current source, and an ac inductive load.
but I think this circuit , shows a few more pieces.
He then describes Rainy Season and Lightning.
So, the voltage could go up to 500 volts, and the fuse will not open up.
But… the neutral is now “floating” because of the 1 ohm resistance.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
This is 'the assistant's answer'
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
The bolt then partially travels down the line to your home.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
2024–10–16 [ OO OLAOYE OYEBODE ]
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Barnstars:
These are simplified answers to the original question, and does not change anything I wrote above.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Edit 2024–10.
At one ohm, the resistor has a maximum of 1 watt power.
a photo is worth a thousand words.
In schematic diagrams this is the symbol for a fuse:
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
[old diagram got deleted by accident]
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
For this case there are devices called Metal oxide varistors (MOV).
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
A fuse is a non-resetable over current circuit protector.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
[image of Common-mode choke]
Here is a simplified AC power diagram.
One
What does a fuse do?
One is “what exactly is in a ‘surge protector’ ? ”
A circuit breaker is similar, but is resettable.
I post the exact comment here.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
nine